Help Center

Add a Group of Points

Adding a group of Points

CAD drafting Add a Group of Points 0   Ribbon: Topoplan – Modify TIN > CAD software Add a Group of Points 1 Adding a Group of Points

CAD drawing Add a Group of Points 2   Menu: Topoplan – Modify TIN > CAD drafting Add a Group of Points 3 Adding a Group of Points

CAD software Add a Group of Points 4   Toolbar: Modify TIN > CAD drawing Add a Group of Points 5 Adding a Group of Points

CAD drafting Add a Group of Points 6 Command line: NG_MESH_VERTEX_ADD_BY_POINTS

The command adds a group of points (geopoints, blocks) to the surface using the interpolation principle.

To add a group of points:

     

1.    Select one surface.

 In response to a prompt on the command line -

Select point type or [Points/COGOPoints/Blocks]:

select the type of points.

3.    In the Properties bar, configure the command parameters

CAD software Add a Group of Points 7

Addition type

Project on mesh – Project points of the mesh surface.

By point – take current coordinates without projection.

Elevation source

The parameter is available when selecting the By point addition type

Selection of the elevation source.

For points:

– Position

For COGOPoints:

– Position

– Custom property

For blocks:

– Position

– Attribute

Projection

The direction in which points will be projected onto the surface (WCS, UCS or Viewport).

Update points

The data of the point to be updated.

No – we change the surface, but do not change the starting points.

Position – we change the surface, as well as the position of the points to a new one, projected onto the surface.

 

We collect Cookies
We use cookies to ensure that we give you the best experience on our website. By clicking “Accept”, you agree to our website’s cookie use as described in our Privacy Statement.

↑