De 
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Cut Mesh
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Cut Mesh
Ribbon: Topoplan – Modify TIN > 
Cut Mesh
Menu: Ground – Editing TIN > 
Cut Mesh
Toolbar: Editing TIN > Cut Mesh
Command line: NG_MESH_CUT
The command’s purpose is to split a mesh into divisions.
The command options are set on the Properties bar.
Options:
|
Save result as |
Influences on objects that will be created in the process of performing the command: a Submesh or Polyfacemesh can be created. |
|
Delete source mesh |
Yes – as a result of the command, several meshes will be created, and a source mesh will be deleted. No – as a result of the command, several meshes will be created, while the source mesh will also remain in a drawing. |
|
Specify closed contour |
onScreen – after changes are applied, indicate the nodes of cutting contour with the cursor; Selection – for cutting, select a previously prepared closed polyline in a drawing; Profile – indicate by the cursor the nodes in a drawing with possibility to extend the cutting profile to the mesh edges (Extendall option) or to close (Close option; if this option is selected, the result will be similar to selecting the onScreen option). |
Command prompts:
|
Apply changes <Yes> or [Yes/No]: |
Yes – cutting will be performed with the current settings. No – if settings have been changed, they are not saved. Cutting will be performed with the settings that were displayed immediately after running the command. |